AlarmReceiver( )
|
Provides support for receiving alarm reports
from a burglar or fire alarm panel
|
AlarmReceiver( )
Emulates an alarm receiver, and allows Asterisk
to receive and decode special data from fire and/or burglar alarm
panels. At this time, only the Ademco Contact ID format is
supported.
When called, AlarmReceiver( ) will
handshake with the alarm panel, receive events, validate them,
handshake them, and store them until the panel hangs up. Once the
panel hangs up, the application will run the command line specified
by the eventcmd setting in alarmreceiver.conf and pipe the events to the
standard input of the application. alarmreceiver.conf also contains settings for
DTMF timing and for the loudness of the acknowledgment tones.
|
This application is not guaranteed to be
reliable, so don't depend on it unless you have extensively tested
it. If you use this application without extensive testing, you may
be putting your life and property at great risk.
|
|
This application always returns 0.
; set up Asterisk to answer a call from a supported fire alarm panel
exten => s,1,AlarmReceiver( )
See Also
alarmreceiver.conf
|